How much does tongue and groove pine cost?

Tongue and groove typically costs between $1.25 — $1.60 per linear foot, or around $2.50 to $3.00 per square foot. Some wood species, like cedar, will cost you way more than yellow pine or spruce.

What sizes do tongue and groove boards come in?

Available Lengths: 8′, 10′, 12′, 14′, and 16′.

Are there different types of tongue and groove boards?

Tongue & Groove Patterns (T&G) have the greatest variation in profile – the outline or shape of the board. How distinct or shadowed the line between the boards appears after installation depends on the shape of the edge – the pattern profile you choose.

How wide is 1×6 tongue and groove pine boards?

Is Knotty pine expensive?

“There’s knotty pine and clear pine and the clear is quite expensive,” reports Bob Laurie of L.L. Johnson Lumber in Charlotte, Mich. “When people want knotty pine, they usually want to purposely incorporate knots and they need the knots to be tight and sound. It’s in demand and it’s under a dollar a foot.

Can I use pine tongue and groove outside?

Nothing adds elegance like installing tongue and groove pine siding. The construction gives this type of siding its distinctive look and durability. It can be used both inside and outside, and it can be painted, stained, or clear coated for a beautiful natural-looking finish.

What wood is used for tongue and groove?

pine wood
Tongue and groove pine wood fit together using an interlocking technique in which one edge of a pine board resembles a tongue, and the other edge is an opening for the tongue to be held in place, known as a groove. This is a very secure way of fitting wood together to install floors, ceilings, or walls.

How thick is knotty pine tongue and groove?

Cedar Paneling – is 3/4″ thick and available in 4″, 5″ and 6″. Prefinished in 6″ size only. Our natural knotty pine paneling is tongue and groove and end-matched for zero-waste.

What are the disadvantages of a tongue and groove joint?

The single disadvantage might be that the joint is visible from the end of the panel. The tongue-and-groove joint is often used to form wider panels from narrower boards, such as when forming table tops, doors, or architectural paneling. It’s also widely used for strip flooring.

Which is cheaper shiplap or tongue and groove?

Shiplap is cheaper than tongue and groove, but it requires a bit more work on the carpenter to get the rows to lay flat against the building in a waterproof fashion. Also, if not installed properly, shiplap is more likely to warp and leak than its counterpart.

How much tongue and groove pine do I need?

If you are using 1×8 T&G, the face coverage is 6.875, therefore you would multiply your square footage by 12 and divide by 6.875. Finally, always account for about 5% waste factor so that you do not run short. To do this, multiply your final lineal footage by 1.05 and that will be the amount to order.