What is the electric load detector?

The Electronic Load Detector (ELD) detects any electical load on the engine from accessories like A/C controls, radiator fan, lights, heater motor, etc. The ECU uses the ELD’s inputs to adjust alternator output and compensate for the additional electrical loads.

What is the eld on a Honda Civic?

Honda’s answer to this is the ELD (Electrical Load Detector). This unit reads the amperage load directly from the battery and in-turn sends a varied voltage signal to the PCM which regulates the field signal to the alternator.

What is p1361 for Honda Civic?

The Honda Civic code p1361 means that the crankshaft position sensor is not working correctly. This is a part of the system that controls the timing of the pistons in the engine. If You do not fix this issue You will notice short term problems like shuddering, stalling, and rough idle.

What is code P1298 for a Honda Civic?

Error Code P1298 is defined as Electric Load Detector Circuit High Voltage. This means the ELD (Electric Load Detector) is getting high input voltage.

What does P1456 mean?

Error Code P1456 is described as a Evaporative Emission Control System Leak. This means there’s a leak problem in the EVAP (Evaporative Emission Control System), particularly on the tank side, and the engine’s computer has detected the issue.

What are the symptoms of a bad eld?

Usually, there are no other noticeable symptoms. In some cases, however, the engine may suffer rough idle, especially when the vehicle settles down or transitions from high throttle to rest, or the engine feels like it’s misfiring.

What is Honda Civic 2001 eld?

The ELD sends a signal to the engine control computer so that the computer can adjust the alternator output in relation to power consumption. The ELD is located in the underhood fuse box.

What is code P1456 on Honda Civic?

What it means: OBD-II code P1456 represents a problem with the EVAP control system on your Honda. The EVAP control system on your Honda temporarily stores fuel vapors from the fuel tank in a canister to stop it from escaping into the atmosphere. A faulty fuel cap could set off this engine code.

How much does it cost to fix a leak in the EVAP system?

EVAP Leak Repair Cost: Everything You Need to Know. When your check engine light goes off it could be for a number of reasons and one of them is relating to an EVAP leak in your fuel evaporative system. The cost of repairing your EVAP system can range from $200 to as much as $600 or more.

What does the code p1298 mean on a Honda Accord?

What Does Code P1298 Mean? If your Honda vehicle has stored a code P1298, it means that the powertrain control module (PCM) has detected a problem with part of the charging system known as the electronic load detector (ELD) or ELD circuit.

What does error code p1298 mean on Eld?

Error Code P1298 is defined as Electric Load Detector Circuit High Voltage. This means the ELD (Electric Load Detector) is getting high input voltage. This error code is a manufacturer-specific trouble code, meaning it does not appear to all vehicle makes and models with OBD-II system or vehicles made since 1996 up to present.

When does a PCM get a code p1298?

If the PCM detects a voltage signal from the ELD circuit that is greater than the degree of voltage it expected the alternator to produce at a given time and under a specific set of circumstances, a code P1298 will be stored and a malfunction indicator lamp (MIL) may be illuminated. What are the common causes of code P1298?

How to reset the p1298 load detector code?

Connect the scanner to the vehicle diagnostic connector and retrieve stored codes and freeze frame data. Write it down as it will almost always come in handy if the diagnosis drags on due to an intermittent condition. Clear the codes and operate the vehicle under various electrical load conditions to see if the code P1298 is reset.