Miscellaneous

How do I program my Shaw remote to my receiver?

How do I program my Shaw remote to my receiver?

How to program your remote to your receiver

  1. Press and hold SAT button until the others (TV, AUX) flash at least 3 to 4 times.
  2. Press the 3 digit remote code: 000.
  3. After punching in the code, press the POWER button and see if the receiver turns off.
  4. If receiver turns off, your remote has been successfully programmed.

How do I get a new remote from Shaw Direct?

If you require a replacement remote for your Shaw digital box, you can contact us to have a replacement remote control mailed out to you. Before contacting us, please identify the type of remote that you have (for example a BlueCurve TV, Gateway, or Atlas remote).

What to do if your Shaw remote is not working?

Contents

  1. Check the remote control.
  2. Reset the digital box.
  3. Check the front panel buttons for a response.
  4. Change the batteries in your remote.
  5. Reprogram your Shaw remote.

How do I program my Shaw remote to skip 30 seconds?

To adjust the skip length to 30 seconds:

  1. Press EXIT – EXIT – EXIT – 0 – 0 – 3 – 0 on the BlueCurve TV remote.
  2. Adjusted skip length will be 30 seconds forward and 15 seconds back on Live TV, PVR recordings and On Demand content.

How do I pair my Shaw remote to my Shaw box?

Quick setup remote pairing

  1. Press and hold SETUP until the remote light turns green green.
  2. Press the SHAW button. The remote light will start blinking green.
  3. Press the SHAW button again.
  4. Enter the number sequence shown on the TV by pressing the numbers on your remote control.

How do I reset my Shaw remote control?

To perform a factory reset:

  1. Activate the programming mode on your remote.
  2. Press 9 – 8 – 1.
  3. The LED will blink green twice to indicate that the remote was reset.
  4. After the factory reset is complete, you’ll need to re-pair your remote with a TV box.

How do I resync my directv remote to my receiver?

Make sure your remote is paired with your receiver.

  1. Point the remote at your Genie, Genie Mini, or Wireless Genie Mini.
  2. Press and hold MUTE and ENTER at the same time on your remote.
  3. The screen displays Applying IR/RF Setup. The remote is synced.

How do I sync my new bell remote to my receiver?

  1. Press SYS INFO on the front of the receiver.
  2. Press and hold SAT until SAT, TV, AUX and VCR light up.
  3. Release SAT. It will start to flash.
  4. Choose a random number between 0 and 16 and enter it. This will reset the frequency the remote uses to communicate with the receiver.
  5. Press #.
  6. Press Record.
  7. Press Done.

Why does TV remote not change channels?

Remote will not change channels or turn on the TV. Batteries are low, dead, or inserted incorrectly. If the box turns ON or OFF, then install new batteries in the remote and try again. Make sure the equipment is plugged in to an active power outlet.