How do you fix an E10 error on an Electrolux washing machine?

Clean the pump and filter. Clean the pump and fluff filter, including the pump blade (if the pump blade is visible, rotate it with a pencil and refit the filter). Then start a hot wash without adding any detergent powder to clean out the drainage system.

What does E10 error mean?

Seeing E10 or ten repeated flashes of the LED on your display panel between pauses means your machine has identified a specific problem. Error code E10 relates to a fault either with the timer (on older models) or with the drum sensor that ensures the drum is in the correct position.

How do I force my Electrolux washer to drain?

Drain Pump Guard Filter

1. Open the pump guard panel.
2. Pull the emergency hose out.
3. Place the hose in a container and remove its cap.
4. Unscrew the pump guard filter.
5. Wash the filter in the sink to clean it.
6. With the filter out, check the pump impeller.
7. Put the pump guard filter and emergency hose back into the machine.

What does E10 mean on Beko washing machine?

jammed
E10 tells you the door is jammed. Either of these codes means you need to call in a Beko repair expert.

Why does my Electrolux washer say no water?

Common solutions for: Electrolux F/H – FH No Water Entering Machine or Pressure Switch Failure. Make sure water supply valves to washer are turned on. Check fill hoses to washer for kinks or clogged screens at water inlet valve. If this happens the water inlet valve or the water level pressure switch may be defective.

What does E10 mean on an AEG washing machine?

AEG failure E10, C1 or F1 When you see E10, C1 or F1 on the display, the washing machine doesn’t get enough water. Open the tap fully and then close it. To be safe, place a towel under the supply hose and remove the plug from the socket. Disconnect the supply hose from the tap and clean the filter.

What does code E10 mean on Logik washing machine?

Water drain time out or
Logik Washing Machine Error 10: “E10” Error Code Definition: Water drain time out or failure. The washing machine has failed to drain the water in allotted time (6 minutes).

Can you reset Electrolux washing machine?

First, you should perform a general reset of the machine. Turn the machine off at the powerpoint, wait for one minute, and then turn it back on. If you see no change, you can try a Master Reset. This will reset all of the onboard componentry and is often successfully used by appliance technicians.

Why is my Electrolux washing machine not working?

Cause: Possible imbalance – the electronic balance check ensures that the clothing is balanced inside the washing machine before the appliance starts to spin. Clogged filter – if the drainage does not function properly, it may cause the machine not to spin.