What date in Subpart X requires metal ladders to have rungs that are skid resistant?

(a)(6)(i) The rungs and steps of fixed metal ladders manufactured after March 15, 1991, must be corrugated, knurled, dimpled, coated with skid-resistant material, or otherwise treated to minimize slipping.

What subpart covers stairways and ladders?

Subpart X
1926 Subpart X – Stairways and Ladders | Occupational Safety and Health Administration.

What does CFR Part 1926 cover?

29 CFR Part 1926 – SAFETY AND HEALTH REGULATIONS FOR CONSTRUCTION. Source: This republication developed a single set of OSHA regulations for both labor and management forces within the construction industry.

What are the OSHA requirements for ladder?

All Ladders Maintain ladders free of oil, grease and other slipping hazards. Do not load ladders beyond their maximum intended load nor beyond their manufacturer’s rated capacity. Use ladders only for their designed purpose. Use ladders only on stable and level surfaces unless secured to prevent accidental movement.

What is the maximum height you can work from a ladder?

There is no maximum height for using a ladder. However, where a ladder rises 9 metres or more above its base, landing areas or rest platforms should be provided at suitable intervals.

Do ladders expire?

You should always check your ladders before use for cracks, bends or breaks in any part of the ladder. Remember that there is no expiration date for ladders, so as long as you follow proper storage techniques and treat it with care, your ladder could last you an extremely long time.

What height should a ladder rise above and beyond the place of landing?

For access to an elevated work surface, erect ladders so that a minimum of 1 m (3 ft) extends above a landing platform.

What should completely encircle the ladder?

Wells must completely encircle the ladder. Inside widths of wells must be at least 30 inches (76 cm). Inside faces of wells on the climbing side of the ladder must extend between 27 inches (68 cm) and 30 inches (76 cm) from the centerline of the step or rung. Wells must be free of projections.

What does 29 CFR 1910 stand for?

To assist the employer in identifying which General Industry Standards apply to them, questions regarding the subparts and subsequent standards are provided to help the employer identify which are applicable to them.

What is the most cited OSHA violation?

10th year running: Fall Protection leads OSHA’s annual ‘Top 10’ list of most frequently cited violations

• Fall Protection – General Requirements (29 CFR 1926.501): 5,424 violations.
• Hazard Communication (1910.1200): 3,199.
• Respiratory Protection (1910.134): 2,649.
• Scaffolding (1926.451): 2,538.
• Ladders (1926.1053): 2,129.

What height do you need to wear a harness?

Currently, OSHA requires that employers provide fall protection for construction workers on a walking or working surface with an unprotected edge that is 6 feet or more above a lower level.

At what height do you need a harness?

Personal Fall Arrest Systems OSHA requires workers to wear a full-body harness, (one part of a Personal Fall Arrest System) when they are working on a suspended scaffold more than 10 feet above the working surface, or when they are working in bucket truck or aerial lift.