What size is a standard prop nut?

1-1/16″
Prop Nut Compatibility: 1-1/16″ Nut (the standard size nut for 1″, 1-1/8″, and spline shafts)

What size socket do I need to remove a boat prop?

Use a 1-1/16″ socket with a 3 inch extension or a 1-1/16″ DEEP socket. Do NOT put the motor in gear. DO use a block of 2×4 to place between the cavitation plate and one propeller blade. The threads are standard rotation.

What size is the prop nut on Mercury 250 Pro XS?

1-1/16 is correct, it was the same size on all three of my engines, 200 EFI, 200 Pro XS and 250 Pro XS w/ fat shaft, T.M. lower.

What size is a prop wrench?

1 1/16″
The Prop Master™ is the original molded propeller wrench. This 1 1/16″ six point socket style prop wrench is made of high tensile strength, indestructible nylon.

What size is Yamaha prop nut?

It is an 1-1/16″ socket.

Are propeller nuts reverse threaded?

Prop nuts are basically M5 nylon nuts. In hardware stores, they are refereed to as right handed and left handed thread as opposed to CW and CCW.

How do you tighten a prop on a nut?

Remove the cotter pin and the first nut. Tighten the thin nut to the prop to spec and mark where one of the nut flats is relative to the prop then loosen and tighten again; if that mark realigns you are done. Then the thick nut and cotter pin.

Will a mercury prop fit a Yamaha?

By using the Mercury thrust washer and outer tab locking washer from Mercury,it will work fine. If you use the Yamaha thrust washer it is best to cut off the line cutter to keep it from getting into the seals. WE spun a hub on our yamaha prop.. When we had a yamaha, we then threw on a Mercury, it worked fine.

What kind of propellers do I need for my Verado?

Find the right Propeller that fits your Mercury Verado Outboard of Mercury X/R Sterndrive from SOLAS Lexor 3 Plus, Powertech Propellers OFS5 or the tried and true Mercury Bravo 1 in just a few clicks, SALE Pricing, Same Day Shipping available.

What kind of propellers do I need for a Mercury 350?

Get A Prop has handpicked the best selection of Stainless Steel Propellers for Mercury 350 in 3 and 4 blades with the interchangeable Quicksilver 840389Q06 Flo-Torq 2 HD Hub Kit or Solas Rubex RBX123 Hub Kit.

Do You Torque the prop nut on an outboard motor?

Purchase a purpose designed plastic prop wrench, you do not torque the prop nut. Set your outboard motor up so it is stable and you can easily access both the engine and the propeller. Your propeller is held on with a scotter pin, inserted through the propeller shaft.

How big of a socket do I need for the prop nut?

OBTW: We got a 40-50# stingray and 2 flounder between 14″ and 16 1/2″ – neither legal keepers (they’re back getter bigger for the next trip). Thanks in advance for your help. More sharing options… 1 1/16″, most marine supply stores carry a nylon prop wrench or you can pick up a socket.